Table of Contents
Advertisement
APPENDIX I — 269 Commissioning Summary
PAGE 5: SETPOINT VALUES
SYSTEM CONFIGURATION
Norm Run Disp Line
Norm Run Disp Page
4
Defeat No Sensor Alarm
Enable Low Temp. Alarm
Enable
Stator
RTD
4
Voting
4
Defeat RTD Input
RTD Bias Curve Min (°C)
5
RTD Bias Center (%)
5
RTD Bias Center Temp(°C)
RTD Bias Curve Max (°C)
5
Defeat Unbalance Input
6
Default K Value
Running Cool Time (min)
Stopped Cool Time (min)
4
RTD 8 Ambient Sensor
Analog Output
Analog Output Type
Motor Load Anlg.Output FS
Relay Alarm Latchcode
7
Drawout Failsafe Code
Relay Failsafe Code
Sp. Inp. to Read 52B?
Time Between Starts (min)
FLC Therm. Cap. Red. (%)
TC Used Alarm Level (%)
TC Used Alarm Delay (sec)
4
Not seen if no RTDs are
connected (see note 3)
5
Not seen if "Defeat RTD Input" is
YES
6
Not seen if "Defeat U/B Input" is
YES
7
Only seen if 269 is a drawout relay
NOTE: Shaded setpoints in commissioning summary have
been added or altered as compared to last revision
I-4
PAGE 6: SETPOINT VALUES
MULTILIN SERVICE CODES
Applicable for Service
4
Application Only.
Place 269 in test mode?
5
Software Access
Encrypted Code
PAGE 7: SETPOINT VALUES
METERING SETPOINTS
Setpoints Set/On Line?
Meter CT Primary (amps)
V.T. Ratio
Meter VT Secondary (V)
U/V Trip/Alarm Avg V=0?
U/V Alarm Level (%VT)
U/V Alarm Delay (sec)
U/V Trip Level (%VT)
U/V Trip Delay (sec)
O/V Alarm Level (%VT)
O/V Alarm Delay (sec)
O/V Trip Level (%VT)
O/V Trip Delay (sec)
Block PF Prot. on Start
PF
Protection
Delay
8
(sec)
9
Blk PF Alm/Trip by (sec)
PF Lead Alarm Level
PF Lag Alarm Level
PF Alarm Delay (sec)
PF Lead Trip Level
PF Lag Trip Level
PF Trip Delay (sec)
Pos KVAR Alarm Level
Neg KVAR Alarm Level
KVAR Alarm Delay
Voltage Phase Rev.?
Scale Factor
8
Not seen if "Block PF Protection
on Start" is YES
9
Not seen if "Block PF Protection
on Start" is NO
269.D6.0.4
Advertisement
Chapters
Table of Contents
