Work Commands - Marini Quarry Votager Operating And Maintenance Manual

WORK
control panel
An emergency stop button (E) is found on the WORK
control panel (fig.68).
Press the button (E) to stop the machine in an emergency.
When pressed, the button remains in this position. Before
restarting the machine, turn the button clockwise to return it
to its original position and then reset the safety device
interlock by pressing the button (S).
Note: the push button (S) is not installed on the
electrical and diesel power pack, the motor start up
button rest automatically the emergency devices.
POSITIONING
A
Figure 70
WARNING: before turn the switch on WORK make sure that the air delivery
hose is connected ( see pag. 33). If there is not air pressure or is not enough , the
machine will stop when you turn the switch on WORK .
072010

WORK COMMANDS

POSITIONING
Figure 67
WORKING
POSITIONING
positioning operation make sure that the switch A is in the
WORK position ( figure 70).
control panel
WARNING: start drilling only
after having efficiently stabilized
the slide.
/ WORK:
47
E
WORK control panel
Fig. 68
E
S
Before performing
Fig. 69
any