General Information Regarding Safety; Safety Rules - Marini Quarry Votager Operating And Maintenance Manual

General information regarding safety

In the design and building of this machine, the criteria and procedures to meet the basic safety requirements foreseen by
European directive 2006/42/CE
In particular, measures were taken during the design and construction phase in order to prevent risks to the operators.
All the documentation regarding the adopted safety measures is contained in the technical file located at the offices of
Marini Quarries Group Srl.
For certain risks, solutions could not be found from a design point of view. In these cases, the safety measures to be
followed in order to operate as safely as possible are reported.
CAUTION: Marini Quarries Group recommends that the instructions,
procedures and recommendations provided in this manual be followed, that
all the suggested precautions for good technique be adopted and that the
current safety regulations be observed.

Safety rules

- The installation, maintenance and use of the machine is reserved for specialized personnel only.
- Make sure that the power supply has been shut off before performing any cleaning or maintenance interventions.
- Do not remove the machine guards that protect the moving parts.
- Do not place your hands inside parts where there is the risk of crushing and/or entanglement.
- During the work and positioning operations, the operator must stay at a safe distance with the remote control, in as
protected a position as possible.
- The lifting and transport of the machine as well as the handling of parts of the machine must be done with the machine
off by specialized personnel using suitable equipment.
- If machine components need to be replaced, use only original replacement parts.
Risks determined through analysis of the dangers and hazardous situations while working
Contact with overhead electrical lines, impacts, beating, compressions, vibrations, slipping, falling, noise, shearing,
grinding, falling of material from above, mineral oil and derivatives, remote controlled mechanical moving parts, safe
distances.
IT IS FORBIDDEN TO TOUCH EITHER THE HAMMER
OPERATIONSENTANGLEMENT AND CRUSHING RISK
072010
CAUTION
OR THE RODS DURING DRILLING
15