Checks Before Use - Marini Quarry Votager Operating And Maintenance Manual

Before starting the machine:
1. Ensure that the machine is in perfect working order. For this, perform the following operational
checks and controls in order to obtain improved productivity and also to meet all the safety
regulations.
CAUTION: IT IS FORBIDDEN TO BEGIN USING THIS MACHINE
unless this manual has been read and completely understood.
TO PERFORM THE CHECKS LISTED BELOW, ALSO REFER TO THE SECTION:
MAINTENANCE OPERATIONS AND ADJUSTMENTS.
- Engine oil level (check and top off if necessary)
- Hydraulic fluid level (check and top off if necessary)
- Status of the rubber tracks (check condition)
- Fuel level
- Safety devices and emergency buttons (check their condition and that they are
working properly)
- Check that the brakes on the self-moving carriage are working properly
A more accurate check should be done after a long period of machine downtime. If faults occur,
contact a service center that is authorized by the manufacturer.
2. Cleaning check
- Remove waste / dust / dirt from the remote control, motor, joints and radiators.
- Clean all the safety decals as well as the maneuver indications.
3. Check for damage
- Check that there are no damaged or missing parts.
- Make sure that all the joint pins are properly seated.
- Check below the machine for any oil or fuel leaks.
- Check the tightness of the screws and bolts.
MANDATORY MACHINE DOWNTIME: If there is the risk that the defect could
compromise safety or cause further damage, the machine must not be used
until it has been repaired and tested.
072010

CHECKS BEFORE USE

23