An emergency stop button (E) is found on the control panel used for
positioning (fig. 45).
Press the button (E) to stop the machine in an emergency.
When pressed, the button remains in this position. Before restarting the
machine, turn the button clockwise to return it to its original position
and then reset the safety device interlock by pressing the button (S).
Note: the push button (S) is not installed on the electrical power pack, the motor start
up button rest automatically the emergency devices.
POSITIONING
A
.
Figure 48
Moving the vehicle
Use the levers on the control panel to move the vehicle
(fig. 47).
The lever on the right controls the right track, while the
lever on the left controls the left track.
Pull both levers towards you to move backwards, and vice
versa for moving forward.
To turn right, pull the right lever towards you.
To turn left, pull the left lever towards you.
072010
POSITIONING CONTROLS
POSITIONING
control panel
Figure 44
WORKING
POSITIONING
positioning operation make sure that the switch A is in the
POSITIONING position ( figure 46).
CAUTION:
designed to be safely positioned
and
allowable tilt of 10% (~6°).
/
WORK:
39
This
machine
used
with
a
maximum
POSITIONING control
panel
Fig. 45
Before
performing
POSITIONING control panel
Fig. 47
was
E
any