Periodic Checks; Daily; Weekly - Marini Quarry Votager Operating And Maintenance Manual

Adding lubricating oil to the rock drill ll ll ll Adding lubricating oil to the rock dri
Adding lubricating oil to the rock dri Adding lubricating oil to the rock dri
CAUTION: Before adding oil, stop the machine and close the supply of
compressed air and release the air in the control panel; this is important
because it is dangerous to remove the cap or oil reservoir while the control panel
is pressurized.
Fig. 85
Recommended oil:

Periodic checks

Daily:

Weekly:

072010
To add oil to the line lubricator, with the machine off and not
powered, remove the screw cap pos. 11 (Fig. 85) and add oil,
otherwise directly unhook the oil reservoir by putting pressure on
the button pos. 19 (Fig. 85) and turning the ferrule.
If a long downtime period is expected or if the machine is started
after a long period without being used, pour oil directly into the
supply tubes of the rock drill and the feed motor then rotate
them slowly for a few rotations so that the mechanical parts are
well lubricated.
MOBIL ALMO 525 or SHELL TORCULA 100. If either of these is not
available, use an equivalent oil or one that is not very viscous.
Check the oil level in the line lubricator.
Make sure that all bolts and tubes are properly fastened.
Check the hydraulic fluid level in the power unit.
Check the chain tension and adjust if necessary by means of the chain
tightener.
57