Compressed Air Supply System - Marini Quarry Votager Operating And Maintenance Manual

The control panel (Fig. 40) must be supplied at the
following specifications:
Pneumatic hammering for MA100:
4000/4500 lt/min 4000/4500 lt/min
4000/4500 lt/min 4000/4500 lt/min
Pneumatic hammering
hammer:
SEE THE TECHNICAL DATA FOR THE HAMMER SEE THE TECHNICAL DATA FOR THE HAMMER SEE THE TECHNICAL DATA FOR THE HAMMER SEE THE TECHNICAL DATA FOR THE HAMMER
– – – – MAX 6 bar MAX 6 bar
MAX 6 bar MAX 6 bar
Make sure that the valve (H H H H ) and (I I I I ) are closed.
NOTE: the valve ( I ) is an optional required NOTE: the valve ( I ) is an optional required
NOTE: the valve ( I ) is an optional required NOTE: the valve ( I ) is an optional required
for rock drill separate flushing. for rock drill separate flushing. for rock drill separate flushing. for rock drill separate flushing.
Connect the air delivery tube from the compressor to valve (L L L L )
072010

COMPRESSED AIR SUPPLY SYSTEM

- - - - max 6 bar max 6 bar
max 6 bar max 6 bar
for down-the-hole
WARNING: Max working pressure 6 bar
WARNING: the valves (H) and (I) have to be closed before
connect the air delivery hose ( as shown in gigure 40 ).
WARNING: before turn the switch on WORK make sure that
the air delivery hose is connected ( see pag. 33).
In the QUARRY VOYAGER equiped with the valve (L) ,if there
is not air pressure or is not enough , the machine will stop
when you turn the switch on WORK .
WORK control panel
H
31
I
Figure 40
Air line
L