Install The Access Panel; Remove The Air Baffle - Inspur SA5212M4 Manual

To remove the component:
1. Power down the server if performing a non-hot-plug installation or maintenance
procedure.
2. Extend the server from the rack.
3. Use the screwdriver to loosen the security screw on the hood latch.
4. Lift up on the hood latch handle, and then remove the access panel.

4.5 Install the Access Panel

1. Place the access panel on top of the server with the hood latch open. Allow the
panel to extend past the rear of the server.
2. Push down on the hood latch. The access panel slides to a closed position.
3. Use the screwdriver to tighten the security screw on the hood latch.

4.6 Remove the Air Baffle

CAUTION: For proper cooling do not operate the server without the access panel,
air baffle, or fan installed. If the server supports hot-plug components, minimize the
amount of time the access panel is open.
1. Power down the server.
16