Printing Out Stored Data; Printing Out The Function Settings (Printing Test) - Kanomax ANEMOMASTER Series Operation Manual

6. Data Output

6.1.4 Printing Out Stored Data

DISPLAY

6.1.5 Printing Out the Function Settings (Printing Test)

DISPLAY
Example of Data Print Out
<Calculation Result＋Measurement Data>
DATE:2002/10/29
TIME:09:41:29
DATA:063
MODE:VEL TEMP PRS
MAX 7.25 m/s
AVG 5.79 m/s
MIN 2.66 m/s
MAX 22.5 ℃
AVG 21.0 ℃
MIN 19.4 ℃
MAX 0.78 kPa
AVG 0.43 kPa
MIN 0.27 kPa
NUM m/s
01 3.89 21.8 0.33
02 4.41 22.0 0.41
03 5.01 22.4 0.32
Display the Calculation Mode (by pressing
Avg
Normal Measurement screen). While holding down
m/s
Minimum) of all the measurement parameters as well as the stored
measurement data. Please see the below example of printout.
Press
longer on the Normal Measurement screen to print out the function
setting information.
℃
* For details on function setting, refer to "7.2 Other Function Settings"
in page 29.
* This function can be used for test printing.
(This cannot be modified.)
℃ kPa
Analog Output Rang (AirVelocity)
Analog Output Range (Air Temp)
Analog Output Range (Pressure)
PROCEDURE
key to print out the calculation values (Average, Maximum and
PROCEDURE
and keys simultaneously for 2 seconds or
<Information on Function Set-up>
Probe Number
Hardware Setting Info
Baud Rate
Buzzer ON/OFF
Air Velocity Unit
Air Temperature Unit
Pressure Unit
Test Printing
6113 ANEMOMASTER
Ver.1.000
DATE:2002/10/29
TIME:15:06:49
********************
PROBE No. 1
PROBE Type.10
SensorTime 150min
--------------------
HARD SW SETTING
Bit PR ON
Bit PRS ON
--------------------
SOFT SW SETTING
BAUD RATE 4800
BUZZER ON
Vel Unit m/s
Temp Unit ℃
PRS Unit kPa
ANALOG Vel 0 - 5.0
ANALOG Temp 0 – 50.0
ANALOG PRS –5.0 – 5.0
DATE DISPLAY JP
********************
TEST PRINT
0123456789-+/*()
22
key in the
key, press