Inspection Riseatlas - Handicare SystemRoMedic RiseAtlas450 Manual

11. Inspection RiseAtlas

Inspection of shall be performed by authorized personnel and inspections are to be made at the following scenarios.
• First-time inspection – inspection to be performed when first-time installation or first-time assembly has
• Periodic inspection – inspection to be performed annually at least every year on the equipment. Inspection includes
• Verification inspection – inspection to be performed when essential spare parts have been changed and
Note!
Any observations, including defects and damage, of importance for the safety of the lift unit should be noted in the
RiseAtlas logbook which should be retained by the person responsible for the servicing/maintenance of the
RiseAtlas. Also the date when corrective actions are taken, in response to noted observations, should also be noted
in the logbook.
Defects and damage should be reported back to the manufacturer for action and this feedback should be reported
in the logbook.
Every inspection performed on the RiseAtlas shall be noted in the RiseAtlas logbook and a record, such as Inspec-
tion list chapter 11.1, shall be included. The inspection record should be retained safely for examination in the event
of an incident.
If inspection reveals any effect, wear or other damage that jeopardizes the safety of RiseAtlas, the owner should
immediately be notified. In the event of immediate danger to safety, the RiseAtlas should immediately be taken out
of service. It may then not be used until the deficiency has been eliminated.
A checklist for the Inspection is presented in section 11.1 The different inspection categories contain.
A. Visual inspection of RiseAtlas,
0. Inspect the lift for signs of wear and damage.
1. Check the entire length of the strap for signs of damage and inspect seams for wear.
2. Check cables and connections for signs of any wear and correct connection.
3. Check any user notes regarding reported errors in logbook.
4. Check correct labelling and marking of equipment.
5. Check that necessary documentation, manual and service manual and logbook, is available for the lift.
6. Check that the lift works in a correct environment, absence of water and no flammable area.
B. Functionality testing of RiseAtlas,
0. Check start and stop functions.
1. Check charge level and charging function.
2. Check to ensure that hand control markings are consistent with lift functions.
3. Check up/down function and transfer movement (if applicable).
4. Check movement in overhead system.
5. Check limit switch functions.
SystemRoMedic
S E R V I C E M A N U A L
TM
been made to equipment. Inspection includes all categories below.
all categories below.
necessary inspection is stated in chapter 9.
31