Aaeon PCM-5890 Manual page 32

When the PCM-5890's power is applied, the control signal is low until just
after the relevant flat panel signals are present.
Configuration of the VGA interface is done completely via the software
utility. You don't have to set any jumpers. Refer to Chapter 3 for software
setup details.
Refer to Chapter 3 for details on connecting the four standard LCD's: Sharp
LM64183P, Toshiba LTM09C016, Sharp 64C142, and Planar EL Display.
The PCM-5890 is equipped with a high performance 32-bit PCI-
bus Ethernet interface which is fully compliant with IEEE 802.3
10Mbps CSMA/CD standards. It is supported by all major
network operating systems and is 100% Novell NE-2000 compat-
ible.
Configuration is very simple and is done via the Award BIOS
setup. See Chapter 4 for IRQ setup. The medium type can be
configured via the RSET8029.EXE program included on the
utility disk. (See Chapter 3 for detailed information.)
Chapter 2 Installation 23
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com