Save The Configuration - RADVision SCOPIA 100 Quick Start Manual

S
AVE THE
C
ONFIGURATION
M T
AKE RIAL
C
ALLS
16 SCOPIA Gateway Quick Start
100
Procedure
1. In the Gateway interface Port tabs Basics
section, enable the required port.
2. In the Physical Interface, Call Policies and
Supported Services sections, define the settings
you want for this port. Follow your checklist to help
organize the settings.
3. Enable additional ports as required.
4. Check the Same as Port checkbox in the
Physical Interface section to duplicate the
settings from the first serial port in each of the
remaining sections: Physical Interface, Call
Policies and Supported Services.
The Export button on the toolbar allows you to save the Gateway
configuration parameters as an *.ini file to your local hard disk or
to any network directory that you choose.
Procedure
1. In the toolbar, click Export to display the Windows
File Download dialog box.
2. Check the Save this file to disk option. Click OK
to display the Windows Save As dialog box.
3. In the File name text box, type a file name for this
configuration setup.
For example, GW1_NEW
4. Select a location to save the file to and click Save.
As a final step, make a few trial calls following the dialing
sequences described in this section.
Calls are made between the IP network and the ISDN network.
The ISDN network is connected directly to the PRI Gateway or to
an Imux that gives the Serial Gateway access to the ISDN
network.