Table of Contents
Advertisement
C
HECK THE
N
A
ETWORK
DDRESS
S
ETTINGS
S
ET THE
G
ATEKEEPER
A
DDRESS
2.
Enter your user name and password and click OK
to proceed to the configuration page. The default
user name is admin and the default password is
null.
The configuration interface displays.
Use the web interface to check that the network addresses you
set in the previous step were properly recorded by the Gateway.
Procedure
1.
In the sidebar, click the Device button to display
the Device configuration tabs.
2.
Check the settings in the Addressing tab to
ensure that the network addressing parameters
you entered earlier (see
were properly recorded in the Gateway.
Before you can work with the Gateway, you must set a
gatekeeper IP address with which the Gateway registers.
1.
In the Gatekeeper section of the Gateway
interface Settings tab, enter the gatekeeper IP
address in the Gatekeeper Address field.
2.
Click Upload in the toolbar and wait for the
Gateway to reset itself.
3.
Log out by clicking the Logout button in the
sidebar.
Note To review the settings, log in to the Gateway web
interface again.
Procedure on page
Configure the Gateway 13
11)
Advertisement
Table of Contents
