Table of Contents
Advertisement
C
PC
ONNECT TO A
You make the serial connection by connecting a PC terminal
equipped with a terminal emulation application to the front panel
serial port of the Gateway.
Procedure
1.
Run a terminal emulation application (such as
HyperTerminal) on the PC.
2.
Configure the communication settings for the PC
serial port as follows:
9600 Baud rate
8 data bits
1 stop bit
No parity
No flow control
3.
Connect a terminal cable to the PC terminal.
Use the supplied terminal cable to connect the other end
to the Gateway serial port on the front panel.
4.
Start the terminal emulation application on the PC.
5.
Turn on or reset the Gateway.
6.
The following command prompt displays:
Press any Key To start configuration...
Assign an IP Address to the Gateway 9
Advertisement
Table of Contents
