Advertisement
Table of Contents
ACX-200
HARDWIRED ZONE / OUTPUT EXPANDER
The expander enables hardwired devices (detectors, sirens, etc.) to be used in
a wireless system. The expander is designed for use as part of the ABAX two-way
wireless system. It is supported by:
ACU-100 (firmware version 1.05 or newer) / ACU-250 / ACU-120 / ACU-270
controller,
ARU-100 repeater,
INTEGRA 128-WRL control panel.
The expander occupies 4 positions on the list of supported wireless devices.
1. Features
4 programmable hardwired zones:
support for NO and NC type detectors,
support for Single EOL and Double EOL configuration.
4 programmable hardwired outputs (relay).
Remote configuration.
Tamper protection against cover removal.
2. Specifications
Operating frequency band ........................................................ 868,0 MHz ÷ 868,6 MHz
Radio communication range (in open area) ................................................. up to 500 m
Supply voltage ......................................................................................... 12 V DC ±15%
Standby current consumption..............................................................................130 mA
Maximum current consumption ...........................................................................140 mA
Relay contacts rating (resistive load)................................................. 1000 mA / 24 VDC
Security grade according to EN50131-3............................................................. Grade 2
Complied with standards ...... EN 50130-4, EN 50130-5, EN 50131-1, EN 50131-3, EN 50131-5-3
Environmental class according to EN50130-5............................................................... II
Operating temperature range ..................................................................-10 °C...+55 °C
Maximum humidity................................................................................................93±3%
Dimensions ....................................................................................... 126 x 158 x 32 mm
Weight..................................................................................................................... 223 g
Name of certification body .............................................................................Telefication
1471
acx200_en 03/15
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Satel ACX-200
Summary of Contents for Satel ACX-200
-
Page 1: Specifications
1471 ACX-200 HARDWIRED ZONE / OUTPUT EXPANDER acx200_en 03/15 The expander enables hardwired devices (detectors, sirens, etc.) to be used in a wireless system. The expander is designed for use as part of the ABAX two-way wireless system. It is supported by: ... - Page 2 ACX-200 SATEL 3. Electronics board Fig. 1. View of the electronics board. Explanations to Fig. 1: tamper switch. antenna. LEDs indicating the status of the relay outputs: OFF – output inactive, ON – output active. two-color LED status indicator: OFF – power off, ...
- Page 3 SATEL ACX-200 NO1...NO8 - relay output normally open contact. - zone. Z1…Z4 4. Installation Disconnect power before making any electrical connections. The device is designed for indoor installation. It is recommended that the expander be mounted high above the floor. This will allow you to get a better range of radio communication and avoid the risk of the expander being accidentally covered by people moving around the premises.
- Page 4 Note: Taking into account the requirements of EN50131-3 standard, do not enter any values exceeding 300 ms when configuring the sensitivity of zones. Hereby, SATEL sp. z o.o., declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
Need help?
Do you have a question about the ACX-200 and is the answer not in the manual?
Questions and answers