Table of Contents
Advertisement
2
Safety
Before using the E-Stop Rope Switch, a risk evaluation must be performed
according
EN ISO 14121). For mounting, operating and testing, document ERS200 Safe
implementation and operation, application information as well as all applicable
national and international standards, regulations, rules and directives must be
observed. Observe and print out relevant and supplied documents and distribute
to the affected personnel.
The following standards apply for the risk evaluation at the protective device prior
to using the E-Stop Rope Switch:
• EN ISO 14121, Safety of machinery, risk evaluation
• EN ISO 12100-1, Safety of machinery
• EN ISO 13849-1, Safety-related parts of control systems
The realizable category of the integration in control circuits according to
EN ISO 13849-1 is dependent on the used contact block and wiring.
In particular, the following national and international legal regulations apply for the
start-up, technical inspections and work with Safety Switch:
• Machinery directive 2006/42/EC
• Low voltage directive 2006/95/EC
• Use of work equipment directive 89/655 EEC
• Safety regulations
• Accident-prevention regulations and safety rules
• Ordinance on Industrial Safety and Health and Labor Protection Act
• Device Safety Act
For safety-related information you may also contact the local authorities (e.g.,
industrial inspectorate, employer's liability insurance association, labor inspec-
torate, occupational safety and health authority).
Leuze electronic
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
to
valid
standards
(e.g.
EN ISO 12100-1,
ERS200
Safety
EN ISO 13849-1,
7
Advertisement
Table of Contents
