Table of Contents
Advertisement
Speco Technologies
2.
Install and Check Video
2.1.
Installation
1)
Connect the IP Camera to the PC by LAN cable (Crossover Cable)
2)
Supply power to the camera using a 12 volt DC regulated power supply.
3)
Wait approximately 2 minutes until the Link/LED light comes on.
2.2.
Video Check
Basic network setting value of the camera is to be:
IP Address: 192.168.1.7
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
To connect THE CAMERA into the user's PC, change the setting value of the PC network
environment.
Fig. 2―1 Network Setting of User PC
14
IP Camera User's Manual
Advertisement
Table of Contents
