Install The Speed Dome - Speco O4P30X Quick Start Manual

Connect the necessary cables.

1.6.3 Install the speed dome

Step 1
Pull the cable to the wall mount bracket slowly.
Step 2
Line up the straight edge of the flange of the speed dome to the straight edge of the quick
installation port, and then push the speed dome to the bottom of the port slowly.
Step 3
Use your hands to turn the quick installation port M6*14 stainless screw (with spring washer)
to the Ф6.5 hole of the straight edge of the speed dome. Turn other two M6*14 stainless
screws to groove of speed dome flange. Use the inner hex tool to fix these three stainless
screws. Now you have completed the installation. See Figure 1-5.
Step 4
Please make sure:
The three stainless screws of the quick installation port are firmly secured.
The speed dome is fixed.
The speed dome is straight.
The safety hook connection is firm.
After your installation, the interface is shown as in Figure 1-6.
Figure 1-5
4