Table of Contents
Advertisement
Speco Technologies
4.5.2.
Alarm Event Test
Click 'Test' of [4-18], THE CAMERA will work as if Alarm has happened. In case selected 'Alarm
Style
->'Alarm Server', Event is to be notified to Alarm Server and is to recorded into the
recorded file (10 seconds before and 50 seconds after Event), and to be sent to Alarm Server.
In case selected to use user FTP Server, the recorded file (10 seconds before and 50 seconds
after Event) is to be saved in FTP Server. It may take some time for Alarm Message to get to
user's Mobile Phone or by E-mail, in some cases. If THE CAMERA has been registered in Service
Server, it is available to check the details of Event and also change the Alarm Message of E-mail
and Mobile Phone to be sent upon Event, in Alarm Server Homepage (Ipcam4u.net). Refer to
'Use of Service Server' in ' 5. Basic Use' for details.
4.6.
DIO Setting (support for IP-INTT5/T5, IP-SD10X)
Tick on sensor to use and select type of sensor to use.
Sensor Type : designate type of sensor, NC, NO.
Designate name of sensor to use.
4 conditions are selectable for Relay. Relay name is to be input.
Disable: Relay is not active
Fig. 4―19 DIO Setting
41
IP Camera User's Manual
Advertisement
Table of Contents
