Basic Setting; Check Network And Installation Type - Speco & IP-WDRB1 User Manual

Speco Technologies
3.

Basic Setting

3.1.

Check Network and Installation Type

This Chapter is for basic setting of THE CAMERA. To install Hardware of the Network Camera,
basic understanding of Networking is required.
Network Environment is required.
CAMERA without IP sharing Device under Cable Modem or Leased Line, the other one is to install
THE CAMERA under an IP sharing Device , which is required necessarily under PPPoE environment,
and even under Leased Line or Cable Modem. The default IP Address of THE CAMERA is preset to
192.168.1.7 and Subnet Mask to 255.255.255.0 and Gateway to 192.168.1.1 in the factory. This
explanation is based upon default value of the factory.
Caution 1 : Check Video before installation, on
Caution 2 : In case using IP sharing Device, only Global IP is available.
Caution 3 : THE CAMERA does not support PPPoE. IP Sharing Device is required to connect to
THE CAMERA under PPPoE.
Installation without IP sharing device
-> For static IP, refer to 'Static IP Setup'.
-> For dynamic IP, refer to ' Dynamic IP Setup'.
Installation with IP sharing device
-> Should set up with Static IP. Refer to 'Installation with IP Sharing Device'.
Please refer to Chapter 6 in case knowledge of
There are 2 ways to install Hardware.
'2. Install and Video
19
IP Camera User's Manual
One is to install THE
Check'.