Maintenance - Zenith HydroTap G4 Series User Manual

Water Filter
The Zenith HydroTap notifies when filter replacement is due. If you notice
one of the following, you will need to change the filter:
• The Change Filter light will flash white once a second, until reset.
• The filter percentage will show 0% on the Home screen.
Note: Depending on local water quality conditions and usage, the filter may
require changing anywhere from 500 litres to 10 000 litres. You may also
need to replace the filter if you notice unpleasant odours or tastes.
Some water may drip from the filter head (socket) during replacement. Keep
a towel handy to dry up any drips.
To change the Filter:
1. Press [Menu] then [Install] then [Filter Flush].
2. Open the filter access door on the front of the command centre.
3. Reach to the rear right hand side of the filter cartridge and you will
find a flush line (hose), sealed with a stop cock located in the centre
of the hose. Place the free end of the flush line into an empty bucket
or container. Turn the stop cock quickly on then off, to relieve system
pressure.
4. Place a cloth or towel under the filter cartridge to catch any water that
may spill. Gently hold the filter cartridge and rotate the cartridge a
quarter turn to the left, then gently pull down, keeping the cartridge level
to avoid spills.
Caution:
a small amount of water will drip as the cartridge is removed.
5. Place spent cartridge in the sink or suitable container.
6. Unpack the replacement cartridge and remove the sanitary cap. Avoid
touching the filter O-rings or filter opening as this may cause bacterial
contamination of the cartridge.
7. Write today's date where shown on the label.
8. Slightly moisten the O-rings with regular tap water and align the front
cartridge label to the left.
9. Gently but firmly push the cartridge up into the filter head and turn
a quarter turn to the right, as far as it will go without forcing it. The
cartridge should now be locked in position, with the front label facing
forward.
Page 24 of 28
Filter Maintenance
(See also Section C)
802254NZ - HT BC User Guide 10.18 v3.02