Zenith HydroTap G4 Series User Manual page 10

Filter light:
Filter Light Off:
This indicates the filter is operating within its
normal specified lifespan.
Filter Change light flashing slowly:
The light will flash slowly when the filter is due
for replacement and the LCD will show "Filter
Change". Refer to "Replacing the filter" in
section 'C' of this document.
HydroTap Arc/Cube & Celsius AIO:
Flashing filter lights:
All three tap lights (Safety; Select and Indica-
tor light) will flash every
10 seconds, indicating a Filter change is
required.
Turn filter light OFF:
(All models)
Refer to "Filter Reset" in section 'C' of this
document.
Safety Sensor Calibration (lever models)
Light intensity varies from site to site, there-
fore it is recommended that a re-calibration be
performed at the time of the installation.
All direct natural sun light must be shaded
from the HydroTap, during the calibration.
This can be achieved by closing any nearby
curtains, blinds, etc. or by shading the top
slightly. Do not touch or cover the "Safety
Sensor" while calibrating.
Page 10 of 28
Filter Lights
Classic & Elite
Filter Light
Elite Tap
Indicator light
Select light
Safety Light
Arc/Cube Tap
Filter light
Classic Tap
Pull both levers forward
802254NZ - HT BC User Guide 10.18 v3.02
Safety
sensor