Zenith HydroTap G4 Series User Manual page 11

Safety Sensor Calibration (lever models)
With the unit in Normal operating mode and with the safety
1.
enabled
Turn the power OFF
2.
Pull both tap levers to the forward position
3.
Turn ON the power
4.
The unit will calibrate the safety switch
5.
Return the levers to the neutral position.
6.
To check the calibration, dispense Boiling water, in normal light
7.
conditions with the safety enabled.
Zenith HydroTap has a 'TOUCH' screen for easy setup and operation adjust-
ment. See page 26 for icon details.
Other possible messages in status window:
Status**
Safety OFF
Safety ON
System Fault
Sleep Mode
Change Filter
System Off
Hot Isolated
NOTE: As an energy saving feature, the home screen will turn OFF After
5 minutes of non use. Touching the darkened LCD panel will reactivate the
home screen.
802254NZ - HT BC User Guide 10.18 v3.02
LCD Screen
3
Information
Safety lock is deactivated
Safety lock is activated
Product has one or more system
faults
System is in sleep mode. Boiling
water or hot water is not available.
External/Internal filter needs to be
replaced
System off in off mode. No boiling
water or chilled water available.
Hot isolation has been activated.
Boiling water or hot water is not
available.
Notes
-
Refer to section
G - safety
Refer to section B
Refer to section
G - Energy mode
Refer to section C
Refer to section
G - Energy mode
Refer to section
G - Safety
Page 11 of 28