Table of Contents
Advertisement
AutoFire Slide Kiln Controller
Hardware Options
Audible alarm buzzer
The audible alarm can be disabled by removing the circuit board jumper on the back side of the controller. remove
the jumper shunt labeled BUZZ ENABLE along the top edge of the circuit board.
Door/Lid switch
An optional door switch can be installed and connected to the controller. If not used, a jumper shunt is placed at
circuit board location labeled LID.
The door switch acts as an optional safety device to prevent the relay outputs from being energized whenever the
kiln door or lid is open.
Computer software
Computer software is available for remote monitoring and datalogging. The controller has a USB interface that
outputs TIME, Temperature and Setpoint data. For more information on the optional computer software, contact
Orton or visit
www.ortonceramic.com
31
Advertisement
Table of Contents
