Table of Contents
Advertisement
Review or Edit a CONE Program
The operator can edit the active program while the firing is in process. During the active firing, use the Slide
button to select Program. On the CONE SETUP screen, edit the parameters that are active as needed. Some
parameters are not available for editing.
Press the UPDATE button to return to the HOME screen.
Note: When locked, program parameters cannot be changed.
User Program Setup Screen
Custom firing schedules are programmed by setting the desired heating rates, target temperatures and hold times.
35 User Programs are available. The User Program mode allows you to customize your firing schedule and specify
how fast the kiln heats or cools to any temperature. All Programs allow 20 ramp steps. Each ramp step consists of a
heating rate (or cooling rate), a target temperature and a hold time.
Program Name:
Assign a program
name/label
Rate:
Set ramp speed for
each program step
Temp:
Set target temp for
each program step
Load:
Load the program
for the next active
firing
AutoFire Slide Kiln Controller
16
Program:
Select a Program
number 1-35
Fan:
Set Fan control for
each program step
Hold:
Set Hold time for
each program step
Program Lock:
Allow or prevent
program edits
Advertisement
Table of Contents
