Table of Contents
Advertisement
ramp rate and the power to the zone is at maximum (100%). The controller will no longer maintain zone control for
this zone. This condition typically occurs with a failed heating element or relay component.
Diagnostics
Reports the individual thermocouple temperatures, relay activity (ON or OFF) and reports the output power from
0-100% for each output. Amps are reported if the controller is equipped with optional current transformer
hardware.
SKIP
To end a hold before the time has expired or to simply advance to the next program step, use the Skip button. Skip
is not active if the program status is reporting the final program step.
Add Time
To increase the hold time before the time has expired. Add-Time allows the operator to increase the amount of
hold time that is programmed for the current ramp segment in 5 minute increments. Each time the button is
pressed, 5 minutes is added to the total hold time which is displayed directly below the ADD TIME button.
Add-Time changes that are programmed during the kiln firing are not retained in the program memory. These
changes are not permanent and will not appear in the program review after the completion of the firing.
History Screen
The History screen is accessed from the Home screen. Touch the Clock icon at the bottom of the screen.
Recent Results:
Reports the last 3
firing results
Logs:
Slide left for
performance
logs and data
AutoFire Slide Kiln Controller
22
Parts:
Slide right for
part monitors
Advertisement
Table of Contents
