Table of Contents
Advertisement
TEST
Test allows the operator to test the relay outputs and view the thermocouple temperature measurement. Test will
also report the amperage for the system if the optional current transformer is available. Test functions are
dependent on the controller configuration and Model numbers.
Test functions are active for 2 minutes or until the TEST button is pressed again to advance to the next test
function. At the end of the final test function, the test completes.
When active. The controller will activate the specified relay output at 100% power.
Reset
Reset allows the operator to restore the Configuration settings.
Units Screen
The units screen is accessed from the Configuration screen Slide button.
Temperature:
Select Fahrenheit
or Celsius displays
$ / KWHR:
Enter electricity
usage cost from
utility bill.
Last Cost:
View calculated
firing cost
Temperature
Temperature units can be displayed in either degrees Fahrenheit (°F) or degrees Centigrade (°C). Touch to change
the setting.
Rate
Rate units can be programmed as degrees per Hour, Degrees per Minute or Time to Temperature. Touch to arrows
to change the setting.
AutoFire Slide Kiln Controller
28
Rate:
Select degrees per
hour, degrees per
minute or Time
for ramp rates
KW:
Enter Wattage for
kiln or oven
Cone Table:
Look up
temperature
equivalent for
Cones
Advertisement
Table of Contents
