Taylor-Dunn ET 1-50 Operation And Maintenance Manual page 74

POWER TRAIN
"TAYLOR•DUNN
Speed sensor
Sensor set screw
Drive shaft
Figure F • 2b
Disengage the drive shaft from the motor(see "Disengaging the Drive Shaft from the Motor," this section).
Loosen speed sensor set screw. Remove speed sensor.
Figure F - 2c
Rear plate bolts and
nuts
Disconnect power wires from motor terminals.
,,;I/'
r
Front mounting bolts
-~~
Front mounting plate
Front plate mount nuts
Loosen two front plate mount nuts to provide play for the front mounting plate.
Remove four rear mounting plate bolts and nuts.
Remove three front mounting bolts.
Note: Note washers and spacers' position.
Lower the motor and rear mounting plate safely.
Note: The front mounting plate will remain in the truck.
8 • POWER TRAIN
TAYLOR-DUNN: ET 1-50