Forward Reverse Switches - Taylor-Dunn ET 1-50 Operation And Maintenance Manual

9TAYLOR•DUNN
SELECTOR LEVER~
0 0
FOR\./ARD
COMMON
TD PIN *9
Figure H -18. Forward
I
Reverse Switches
Forward
I
Reverse Switches:
Keep the seat switch closed and turn the key switch on. Depress the accelerator.
Check voltage at common on forward
I
reverse switches (Figure H - 18).
If not positive(+} 12V go to ACCELERATOR.
Place selector lever in FORWARD.
ELECTRICAL SYTEM
If voltage at the forward switch normally open (Figure H - 18) is not positive(+) 12V then switch is bad.
STOP.
If voltage at Pin 8 on the control module plug (Figure H - 15) is not positive ( +) 12V then F&R diode/s
(Figure H - 18) are bad. STOP
Place selector lever in REVERSE.
If voltage at the reverse switch normally-open (Figure H - 18) is not(+} 12V then switch is bad. STOP
If voltage at Pin 8 on the control module plug (Figure H - 15) is not positive ( +) 12V then F&R diode/s
(Figure H - 18) are bad. STOP
TAYLOR-DUNN: ET 1-50
ELECTRICAL -
25