Replacing Shift Lever Switches - Taylor-Dunn ET 1-50 Operation And Maintenance Manual

"TAYLOR•DUNN
ELECTRICAL SYTEM
Engage one clip between anchor and assembly. Hold assembly in place against steering column where the old
assembly was removed from. Bend the strap around the column.
Engage the other clip between anchor and assembly. This will hold the assembly fast to the steering column.
Cut the new wires, leaving them enough length to reach under the dash panel, for aesthetic purposes.
Cut one old wire, strip off the end and fasten it to the new wire of the same color. Repeat the procedure for all the
wires.
Nut
Lock washer
Switch mounting screw
Figure H - 12a. Removing shift lever switch
Replacing Shift Lever Switches
Pull up passenger seat.
Unscrew two nuts and remove switch mounting screws. Remove wires from terminals, and install wires on new
switch/es.
The next page shows the proper wiring connection for the shift lever switches.
Mount the switch with the two mounting screws removed earlier.
TAYLOR-DUNN: ET 1-50
ELECTRICAL • 17