STEERING
II
TAYLOR•DUNN
Steering
Clamp assembly
Ball Joint
Figure D -1a
Please refer to Section 1, "SAFETY
I
GENERAL INFORMATION" before performing any repairs
I
maintenance on this vehicle.
Steering Linkages
Replacing the Ball Joints
Remove cotter pins. Unscrew and remove the slotted nuts from both ball joints.
Note position of clamps. Unscrew linkage clamps.
Note:
Half the ball joints have right-hand and half have left-hand threads. For the next step, visually check
whether turning the ball joint clockwise will back it out of the sleeve.
Unscrew and remove the ball joints from the sleeve.
2- STEERING
TAYLOR-DUNN: ET 1-50