Harmar Mobility AL030 Installation & Owner's Manual page 37

Figure 37-1
4. test chair Locking.
Drive chair onto the platform. Test
its locking on the platform. Verify
that the plow's pin engages the Dock
and Lock system. Adjust as needed.
[Figure 37-3]
Raise platform to engage lock and
test the chair to ensure that it is
secure in all directions.
If Dock and Lock station does not
fully retract with platform on the
ground, change to longer linkage as
shown. [Figure 37-4]
Section 2 : inStaller
3. reassemble Dock 'N'
Lock.
Select the holes that
will center the chair width-wise
onto the platform. Use spacers
as required to match the height
of the plow on the chair. [Figure
37-1]
Be sure to use bolts that are
long enough for the bolt's end
to protrude through the upper
nylon portion of nut – but not so
long that the bolts interfere with
the plow. [Figure 37-2]
Outside Lifts - Installation & Owner's Manual 2013
Dock ´n` Lock
Figure 37-2
Figure 37-3
Figure 37-4
37