Harmar Mobility AL030 Installation & Owner's Manual page 23

INStaLLatIoN WIth hItch PoSt
oPtImIzING hItch heIGht
You can vary the lift height
by changing the Hitch
Adapter's orientation and
location. This helps you
optimize the vehicle's
ground clearance to
ensure that the platform
lays flat when it reaches
the end of its travel.
Consult Figure 23-1 to
select the orientation
needed for the vehicle
based on the Hitch
Height, the vehicle's
hitch receiver distance
to the ground.
Refer to pages 15 & 16
for an overview of the
procedure.
Section 2 : inStaller
X X
5"-12" 5"-12"
HHCS, HHCS,
1/2-13 x 3" 1/2-13 x 3"
FULLY THREADED FULLY THREADED
PINCH PINCH
BOLT BOLT
TUBE TUBE
Presses Hitch Adapter Presses Hitch Adapter
against receiver wall against receiver wall
eliminating rattles, eliminating rattles,
and lift movement and lift movement
Outside Lifts - Installation & Owner's Manual 2013
Installation
14"-16" 14"-16"
12"-14" 12"-14"
Figure 23-1
1/2" Hex 1/2" Hex
Nyloc Nut Nyloc Nut
C L A S C L A S
S 2 S 2
THREADED HOLE THREADED HOLE
1/2" Hex 1/2" Hex
Nyloc Nut Nyloc Nut
HHCS, HHCS,
1/2-13 x 3-1/2 or 4"" 1/2-13 x 3-1/2 or 4""
16"-18" 16"-18"
C L A S C L A S
S 3 S 3
Figure 23-2
23