Harmar Mobility AL030 Installation & Owner's Manual page 31

PLATFORM MAY LOOK DIFFERENT PLATFORM MAY LOOK DIFFERENT
THAN ONE DEPICTED BASED THAN ONE DEPICTED BASED
ON MODEL. ON MODEL.
Figure 31-1
Section 2 : inStaller
aL015, aL100, aL100hD, aL160
LIFt aDJUStmeNtS
Note: When adjusting the leg down, ensure
that the top of the threaded rod still protrudes
from the top of the pivot tube. [Figure 31-1]
END OF THREADED ROD END OF THREADED ROD
MUST PROTRUDE THROUGH MUST PROTRUDE THROUGH
TO TOP OF UPPER NUT TO TOP OF UPPER NUT
NUT NUT
SPLIT LOC SPLIT LOC
WASHER WASHER
NUT NUT
SPLIT LOC SPLIT LOC
WASHER WASHER
7. tighten the jam nut to lock it in place,
the foot is positioned properly.
When the lift is properly adjusted, lower the platform
to the ground and raise it back to the transporting
position. Repeat this several times to ensure all parts
operate properly and that the scooter is well secured.
Next, remove the scooter from the lift and, using the
toggle switch, cycle the lift completely up and down to
make sure that all parts are in good working order and
the lift folds when it is empty.
Outside Lifts - Installation & Owner's Manual 2013
Lift Adjustments
(con't)
n u t n u t
t o p t o p
n u t n u t
s e n s e n
L o o L o o
o m o m
o d o d
b o t t b o t t
e d r e d r
a n d a n d r e a d r e a d
r r
s t t h s t t h
e n o e n o
A d j u A d j u
n g t h n g t h
f o o t f o o t
t o l e t o l e
r t e n r t e n
s h o s h o
when
31