Harmar Mobility AL030 Installation & Owner's Manual page 18

Installation
• If the harness is too long, coil the
excess wire and secure it to the vehicle
frame/bumper with the supplied wire
ties. [Figure 18-1]
Do Not
caUtIoN!
4. once harness is run into the vehicle,
remove the pin's protective tubing.
5. Inspect the pin's retaining flanges.
They may have become deformed while
run through the vehicle. These are critical to
secure the pins inside the connector. Adjust
as needed.
6. Flip open end connector's jigned
retainer, insert pins as shown.
Verify the wires can not be pulled out by
moderately pulling on the wires.
Be sure rubber seals are inside back of
connector and close the hinged retainer.
7. Plug connector into the lift.
8. LaSt...attach red wire to the positive
terminal on the battery.
18
Section 2 : inStaller
cut or shorten the harness.
[Figure 18-2]
[Figure 18-3]
P r o t e P r o t e
c t i v e c t i v e
t u b i n t u b i n
g g
3 3
CORRECT CORRECT
LETTERS ARE LETTERS ARE
MOLDED INTO MOLDED INTO
PLASTIC PLASTIC
OR OR
TOP MOUNT TOP MOUNT
SIDE MOUNT SIDE MOUNT
COIL ANY EXCESS COIL ANY EXCESS
WIRE HERE WIRE HERE
DO DO NOT NOT CUT CUT
OR SHORTEN OR SHORTEN
Figure 18-1
IF NEEDED IF NEEDED
ADJUST BY ADJUST BY
4 4 PRYING OUT PRYING OUT
SLIGHTLY SLIGHTLY
5 5
HINGED HINGED
RETAINER RETAINER
SEALS SEALS
Figure 18-2
S T S T
L A L A
Figure 18-3