Figure 10: Local Display - Emerson Copeland EazyCool ZXME020E Application Manuallines

2.10.1 Programming the local display

Figure 10: Local display

LED Mode
On
Flashing
On
On
Flashing
On
Flashing
On
Flashing
On
Flashing
On
On
On
On
Table 14: LED functions description
NOTE: By default, the local display will show the value of the suction pressure during
operation. This can be changed by choosing another value for parameter B03 (Remote
Display visualization).
Setting for
Value shown on the display
B03
0 P1 value = Suction pressure
1 P2 value = Mid-coil temperature (condenser)
2 P3 value = Discharge line temperature
3 P4 value = Vapour inlet EVI
4 P5 value = Vapour outlet EVI
5 P6 value = Ambient temperature
6 P7 value = Not used in factory setting
7 PEr value = Probe error
8 Aou value = Analog output
Table 15: Display visualisation
18
Function
Compressor 1 enabled
Anti-short cycle delay enabled
Condensing fans enabled
Bar display
Programming mode
PSI display
Programming mode
When browsing the service menu
In fast access menu
When browsing the alarm menu
A new alarm occurred
An alarm is occurring
Digital unloader solenoid On
In defrost
Evaporator fans - Liquid line solenoid valve On
Comments
Only for ZXLE
Only for ZXLE
C6.1.6/0117-1017/E