ETC Desire D22 User Manual page 7

ETC Installation Guide
Desire D22
Canopy Fixture Installation
1: Strip the fixture's power wires back
1/2 inch (13 mm).
2: Using the hole in the mounting
bracket, hang the canopy on the
installation hook.
3: Following the label on the
mounting plate, attach the power
wires to the power block.
4: Secure the fixture ground wire to
the mounting plate.
5: If the fixture is the last fixture on a
DMX/RDM line, terminate the fixture. See
6: Insert the DMX/RDM connector into the Terminal board.
7: To determine the alignment of the canopy, orientate the fixture to
where it will need to be focused.
8: Align the holes in the canopy with the mounting posts on the
mounting plate and using a #2 Phillips screwdriver, secure the canopy
to the mounting plate with the canopy screws.
9: Focus the fixture.
10: Tighten the canopy tension nut to set additional resistance for the
rotation of the fixture.
CAUTION: Do not overtighten the canopy tension nut.
Installing the Portable Fixture
The C-clamp attaches the fixture to the
mounting pipe. The position of the fixture can
be adjusted once it is mounted. Tightly fasten
the C-clamp to the yoke with the provided yoke
bolt and lock washer.
1: Place the C-clamp on the mounting pipe,
and then tighten the pipe bolt to secure it.
2: Loop a safety cable over the pipe and
attach the ends to the safety cable loop
on the body of the fixture.
3: Loosen the C-clamp yoke bolt and rotate the yoke to the desired
position.
4: Tighten the bolt to lock the fixture.
Desire D22 Page 7 of 8
Installation
hook and
bracket
Canopy
tension
nut
Termination page 4
on
Safety
loop
.
ETC