ETC Desire D22 User Manual page 6

ETC Installation Guide
Desire D22
2:
3:
Canopy Mounting Plate Installation
1:
2:
3:
4:
5:
6:
7:
Desire D22
If using Category 5:
Cat5 Cable Preparation for
a: See the
IDC Termination Setup Guide
instructions to prepare and
terminate Category 5 for DMX/RDM
input cable to the insulation
displacement connector.
b: Install the IDC connector with wires
terminated to the DMX/RDM Input
receptacle on the termination board.
Optionally, terminate DMX/RDM thru
to the next device in the DMX data run.
Up to 32 DMX/RDM devices can be
daisy-chained together per data run. See
a: See the specific termination setup guide for the type of cable used
(either Belden 9729 or Category 5) in the installation. Termination
kits are ordered separately.
b: Install the connector with wires terminated to the DMX/RDM Thru
receptacle on the termination board.
Terminate DMX/RDM data signal for the last DMX/RDM device in the
data run by setting the termination switch on the termination board to
ON. All other devices in the data run maintain the factory default
termination switch setting OFF. See
Install the divider in the junction box
with the provided screw, separating
the power side from the data side.
Strip the supply power wires back
1/2 inch (13 mm).
Use a #2 Phillips screwdriver to
remove the two screws retaining the
canopy to the mounting plate.
Following the label on the mounting
plate, attach the supply power wires
to the power block on the mounting plate. See
Plate and Termination Board
Attach the power supply ground wire to the mounting plate.
Plug in the input DMX/RDM connector (and thru DMX/RDM
connector, if used) to the appropriate location on the terminal board.
Attach the mounting plate to the junction box, ensuring the cables are
properly routed inside the box.
for
Termination
page 4
on
Page 6 of 8
Cat5 (or equivalent) wire
termination to IDC connector
Control page 2
on
page 4
on
Canopy Mounting
.
.
.
ETC