Network Installation & Setup; Network Initial Setup - Weldex WDP-4602MXV Owner's Instructions Manual

Network Initial Setup

NETWORK INSTALLATION & SETUP
Network Initial Setup
This section describes how to initially set up your Weldex network camera. Initial setup consists of the
following series of steps:
 Locating the unit on the network
 Changing the network settings
Initial setup of the unit requires a computer connected to the same network as the unit(s). Each
Weldex network camera is shipped with the following factory default connection settings:
IP address ⑴
IP subnet mask ⑴
IP gateway address ⑴
Administrator Login ID
Password
Note
(1) If the Network Camera is not able to obtain an IP address from a DHCP server, it will
automatically switch to the following static IP settings:
- IP address : 192.168.0.200
- Subnet mask : 255.255.255.0
- Gateway address : 192.168.0.1
The following Transmission Control Protocol (TCP) ports must be open on the network:
 80 (web based configuration port)
 554~558 (RTSP video delivery port)
Once you have initially set up your unit, you are ready to configure the rest of the unit's settings.
This document contains confidential and proprietary information of Weldex Corporation.
Setting
NETWORK INSTALLATION & SETUP
Value
DHCP
DHCP
DHCP
admin
9999
16