Table of Contents
Advertisement
Hardware Overview (Appearance)
INSTALLATION
Hardware Overview
Item
① Height-Strip cover : Acryl
② Factory reset switch
③ C-MIC connector
④ Main body Set
⑤ Ethernet port
⑥ Sensor-in/Alarm-out port
⑦ Audio-out port
⑧ Video-out port ⑴
⑨ Power-in port
Note
(1) Video output connector is used only for installation purposes. It should not be used for
recording or surveillance purposes.
This document contains confidential and proprietary information of Weldex Corporation.
Height-Strip cover for the lens and unit protection.
Press and hold this button for 5 seconds while the unit is turned on.
- System LED should be turned ON when performing factory reset.
- The LED next to the switch will flash 3 times after a successful
reset.
Used for microphone input
Main body chassis
Network port
Used for sensor input & alarm output
Use this port to output audio to speakers
Composite Video Output
Power input port (not needed if PoE is being used)
Description
INSTALLATION
10
Hide quick links:
Advertisement
Table of Contents
