Intended Use; Part 2: Installation; Part 3: Functions And Operation; Operation - involight PAINTBAR HEX12PP Manual

1.3 Intended use:

This device is an effect emitter with which decorative light effects can be generated. The INVOLIGHT
"PAINTBAR HEX12PP" can be operated in AUTO mode or music mode. The product is intended for
professional applications, e.g. on stages, in discos, theaters, etc. and is not suitable for room lighting
in households. This product is only approved for connection to 100-240 VAC, 50 / 60Hz alternating
voltage and has been designed for indoor use only. The device must not be used or stored in an
environment in which splash water, rain, moisture or mist can be expected. Moisture or very high
humidity can reduce the insulation and lead to fatal electric shocks. When using fog machines, please
ensure that the unit is never directly exposed to the fog and is operated at least 0.5 m away from a
fogger. Do not use the unit during a thunderstorm. Overvoltage could destroy the device. Disconnect
the appliance from the mains at all poles. Make sure there are no cables around. You endanger your
own and the safety of third parties! The ambient temperature must be between -5 ° C and + 45 ° C.
Keep the unit away from direct sunlight and radiators. Do not operate the unit until after you have
familiarized yourself with its functions. Do not allow the appliance to be used by persons who are not
familiar with the appliance. Please note that unauthorized modifications to the device are prohibited for
safety reasons. If the device is used in a different way than described in this manual, this can lead to
damage to the product and to the warranty claim. In addition, any other use is associated with hazards
such as short circuit, fire, electric shock, crashes, etc.

Part 2: Installation:

Unpack the unit and carefully check it for damage before using it. Place the unit in a suitable location
or hang it on a suitable crossmember. The device must be secured with an approved safety cable
when the mounting is suspended. In addition, the mounting bracket must be screwed and tightened
with the enclosed screws! Then connect the device to the power supply.
The appliance must not be operated directly after it has been brought from a cold to a warm room. The
resulting condensation may destroy your unit. Leave the unit switched off until it has reached room
temperature!
During installation, the provisions of BGV C1 (formerly VBG 70) and DIN 15560 have to be
observed! The installation may only be carried out by authorized specialists!
IMPORTANT! Overhead mounting requires a high degree of experience. This includes knowledge of
the load-bearing capacity, the installation material used and the safety inspections of the material and
the projector used, but the required experience is not limited to this alone. Under no circumstances
should you try to perform the installation yourself if you do not have the appropriate qualification.
Instead, commission a professional installer. Incorrect installation may result in personal injury and / or
damage to property.

Part 3: Functions and operation:

The device is connected to the power supply via the mains cable. You can adjust and influence the
different operating modes via the on-board menu.

3.1 Operation:

The INVOLIGHT "PaintBAR HEX12PP" is a DMX 512 controllable LED effect light. It can be controlled
via 5, 6 or 41 DMX channels, automatically or music and used as master or slave. The device is
connected to the power supply via the mains cable. A powercon extension (optional) allows the
current to be routed from one to the next device. This allows multiple devices to be powered from a
wall outlet. You can set and influence the different operating modes and via the on-board menu. The
"PaintBAR HEX12PP" can be controlled with any commercially available DMX controller.