Incoming Acceptance And Product Identification; Incoming Acceptance; Product Identification; Storage And Transport - Endress+Hauser Proservo NMS80 Brief Operating Instructions

Proservo NMS80
4

Incoming acceptance and product identification

4.1

Incoming acceptance

Upon receipt of the goods check the following:
• Are the order codes on the delivery note and the product sticker identical?
• Are the goods undamaged?
• Do the nameplate data match the ordering information on the delivery note?
• If required (see nameplate): Are the Safety Instructions (XA) enclosed?
If one of these conditions is not satisfied, contact your Endress+Hauser Sales Center.
4.2

Product identification

The following options are available for identification of the measuring device:
• Nameplate specifications
• Extended order code with breakdown of the device features on the delivery note
• Enter serial numbers from nameplates in W@M Device Viewer
( www.endress.com/deviceviewer
displayed.
• Enter the serial number from the nameplates into the Endress+Hauser Operations App or
scan the 2-D matrix code (QR code) on the nameplate with the Endress+Hauser Operations
App: all the information for the measuring device is displayed.
For an overview of the scope of the associated Technical Documentation, refer to the
following:
• The W@M Device Viewer: Enter the serial number from the nameplate
(www.endress.com/deviceviewer)
• The Endress+Hauser Operations App: Enter the serial number from the nameplate or scan
the 2-D matrix code (QR code) on the nameplate.
4.3

Storage and transport

4.3.1 Storage conditions
• Storage temperature: –50 to +80 °C (–58 to +176 °F)
• Store the device in its original packaging.
4.3.2 Transport
NOTICE
Risk of injury
‣
Transport the measuring device to the measuring point in its original packaging.
‣
Take into account the mass center of the device in order to avoid unintended tilting.
‣
Comply with the safety instructions, transport conditions for devices over 18kg (39.6lbs)
(IEC61010).
Endress+Hauser
): All information about the measuring device is
Incoming acceptance and product identification
9