Setting The Display Language - Endress+Hauser Proservo NMS80 Brief Operating Instructions

Proservo NMS80
G Lower phase
H Tank bottom
1 Gauge reference height
2 Empty
3 Datum plate
4 Ullage level
5 Level
6 Tank reference height
7 High stop
8 Displacer position
9 Standby level
10 Upper interface level
11 Lower interface level
12 Low stop
13 Dipping reference
14 Mechanical stop
15 Slow hoist zone
16 Measured distance
17 Reference position
7.3

Setting the display language

This setting is only relevant for operation via the display module. To set the language in
the operating tool, use the language setting functionality of FieldCare or DeviceCare,
respecitvely.
1. While in the standard view, press E. If required, select Keylock off from the context
menu and press E again.
 The Language parameter appears.
2. Open the Language parameter and select the display language.
3. Confirm your selection by pressing E.
Endress+Hauser
Commissioning
43