Proservo NMS83
G
Lower phase
H
Tank bottom
1
Gauge reference height
2
Empty
3
Datum plate
4
Tank ullage
5
Tank level
6
Tank reference height
7
High stop level
8
Displacer position
9
Standby level
10
Upper interface level
11
Lower interface level
12
Low stop level
13
Dipping reference
14
Mechanical stop
15
Slow hoist zone
16
Distance
17
Reference position
7.3
Setting the display language
Setting the display language via the display module
1.
While in the standard view (), press "E". If required, select Keylock off from the context
menu and press "E" again.
The Language parameter appears.
2.
Open the Language parameter and select the display language.
Setting the display language via an operating tool (e.g. FieldCare)
1.
Navigate to: Setup → Advanced setup → Display → Language
2.
Select the display language.
This setting only affects the language on the display module. To set the language in the
operating tool use the language setting functionality of FieldCare or DeviceCare,
respectively.
Endress+Hauser
Commissioning
39
Need help?
Do you have a question about the Proservo NMS83 and is the answer not in the manual?