G Trouble Shooting; Technical Data - SOMFY Power 1 X 2,5 DC RTS Receiver Operating And Installation Manual

F ADDING AND DELETING
F.1) Adding or deleting a transmitter or a
sensor.
Press the programming button on the Power
1x2,5DC RTS Receiver or the transmitter
A until the blind moves up and down. Then
press the programming button on transmitter
B. It is either saved if the transmitter is new or
deleted if the transmitter is recognized.
Remark : If no remote control is paired, You
can use this mode for the 1st pairing.
F.2) Deleting all transmitters and sensors.
Press the programming button on the Power
1x2,5DC RTS Receiver for approximately
7 seconds. The blind moves up and down
twice:
First time for approximately 2 seconds.
Second time for approximately 7 seconds.
All transmitters have been deleted.
F.3) Back to factory mode
Press the programming button on the Power
1x2,5DC RTS Receiver for approximately
12 seconds. The blind moves up and down
three times:
First time for approximately 2 seconds.
Second time for approximately 7 seconds.
Third time for approximately 12 seconds.
All transmitters and sensors are deleted, up
and down motion durations are deleted.
The product settings are back to default
factory configuration.

G TROUBLE SHOOTING

Nothing works:
Check the wiring (cf SDEV-FICA 38RO).
Check the motor.
Check the power supply.
Check the battery of the transmitter.
Check the compatibility of the transmitter.
Check that the transmitter has been properly
recorded.

TECHNICAL DATA :

Copyright © 2009 Somfy SAS. All rights reserved - V0 - 09/2009
page 74
B
No My position:
The My position can only be programmed if
the timer for raising and lowering the blind
are set.
Problem with the functions :
Check you are in the right mode (Venetian
or Roller).
Lost in your programming mode:
Just make a complete reset and start
again.
A
2 X
3 X
13