Push Handles For Attendant; Table - progeo Basic Light User Manual

7.5

Push handles for attendant

You can assemble these push handles only on a "sport"
backrest tubes that have with no handles.
You can height adjust them in order to offer a better
handhold and a better pushing position to the attendant.
The attendant and/or the user can easily adjust them
and remove them.
To adjust them in height, unscrew the lever L, slide the
tube up or down to the desired height, position the
handle backward and finally screw the lever L tightly.
To remove the push handle, unscrew the lever L and
slide the tube off the support.
To put on the push handle, insert it and let it go through
the support and adjust its height as above mentioned.
Important warning for the attendant: the push handle tubes are safe only when the
two lever L are tightly screwed, in fact, this condition prevents the tubes from sliding up
or down or even coming off accidentally.
Before pushing the wheelchair, make sure the two tubes are safely locked.
Rehateam s.r.l. cannot be responsible for any damage or injury due to neglecting this
warning.
L
L
7.6

Table

This accessory can be assembled only if the wheelchair is equipped with armrests.
To insert the table, loosen the bolt A of the support S on each side of the wheelchair until the hole
is free to let the tube go through.
Insert the tubes parallel into the supports and slide the table to the desired depth.
Finally, tighten the bolt A of both support S.
Before using the table, make sure it is firmly fixed. Try to move it to-and-fro: if it does
not move, it is in condition of use.
To remove the table, loosen the bolt A of the support S on each side of the wheelchair and slide it
off.
.
S
A
Basic Light 24