progeo Basic Light User Manual page 13

FLIP-UP ARMREST
This type of armrest is quite practical. You can swing it up backward and remove it to make transfer
easier. The Flip-up armrest includes a skirt guard.
Always check the armrests are securely
locked in their using position.
If this instruction is ignored the wheelchair or
the user may overbalance.
In order to check the correct position of use, with one
hand, take hold of the armrest on its handhold in front
and try to pull it up.
If correctly locked, the armrest does not come off the
support SA.
SA
L
SA
To flip the armrest up backward, lower the lever L of the support SA, then, pull it up backward.
In this position, you can also turn the armrest behind the backrest pivoting it on the support SP.
To lock the armrest in its using position, first,
make sure the lever L is lowered.
Then, turn the armrest until inserting it into the
support SA. Finally, raise the lever L.
Check the armrest is securely locked as above-
mentioned.
Position of use
SP
SA L
To remove the armrest, you have to swing it back first.
Then, turn it until aligning the two marks M of the support SP. Only in this position, it will possible to
remove the armrest.
Now, pull the armrest off.
A questo punto, facendo ruotare il bracciolo, allineare le due marcature M verticali presenti nella SP
parte superiore ed inferiore del supporto SP.
To insert the armrest, insert the upper part of the
support SP in its lower part.
Then, turn it until aligning the two marks M of the
support SP. Only in this position, it will possible
to insert the armrest.
Once you have inserted the support, swing the
armrest down and lock it following the
instructions previously reported.
The user can also easily height adjust the armrest.
Turn the lever B by 90° and then pull the pad up or push it down to the desired height.
After adjustment, turn the lever B until it locks in one of the holes of the tube T.
T
B
M
M
SP
M
M
SP
Basic Light 13