Table of Contents
Advertisement
POINT OF USE
CONTAINMENT AND
TRANSPORTATION
CLEANING
DISINFECTION
DRYING
MAINTENANCE
STORAGE
MANUFACTURER CONTACT
The instructions provided above have been validated by DENTSPLY as being capable of preparing a medical device for
re-use. It remains the responsibility of the processor to ensure that the processing is actually performed using equip-
ment, materials and trained personnel in the processing facility to achieve the desired result. This requires validation and
routine monitoring of the process. Likewise, any deviation by the processor from the instructions provided should be
properly evaluated for effectiveness and potential adverse consequences.
9. Charging the Cordless Handpiece and Sleep Mode
The cordless handpiece should be charged for at least 2.5 hours prior to first use. The cordless handpiece should then
be recharged after each full day's use. If necessary, the cordless handpiece may be "quick charged" for a single use in 15
minutes. Please note that the cordless handpiece motor will not operate when charging.
Use only the Nupro Freedom™ Cordless Prophy System Power Supply and cord. Failure to do so could cause your
system to malfunction and void your warranty.
9.1
When the bottom charge indicator light on the cordless handpiece
inner module is solid Orange, the cordless handpiece must be charged.
9.2
Plug the power supply into the wall outlet and the mini USB
connector into the charging base. A successful connection is shown
with a Solid Green power-on indicator on back of the charging base.
PRECAUTION: Connect to a single phase AC power 100-240V power
only. Otherwise, malfunction will occur. Do not unplug the power supply
by pulling on the cord.
English • 8
Remove excess soil with disposable cloth or paper wipe. Discard wipe after use.
Handle with care.
Generously spray disinfectant solution on a clean cloth. Wipe the outer surfaces of
the charging base for cordless handpiece, cordless handpiece inner module, optional
wireless foot pedal, power supply and cord. Discard used cloth. Wipe dry with a
clean cloth.
Generously spray disinfectant solution on a clean cloth. Wipe the outer surfaces of
the charging base for cordless handpiece, cordless handpiece inner module, optional
wireless foot pedal, and the power supply and its cord.
Discard used cloth.
Allow disinfectant to air dry.
When cleaning, wipe surfaces dry with a clean cloth. To achieve disinfection, allow
surfaces to air dry.
Visually inspect to ensure that all contamination has been removed.
Visually inspect power supply and cord for damage.
Temperature range: -20°C to 50°C
Relative humidity range: 45 - 95% (non-condensing)
In the United States, contact DENTSPLY Professional Customer Service Technical
Support at 800-989-8826. For areas outside the United States, contact your local
DENTSPLY Division.
Power supply
connector
Hide quick links:
Advertisement
Table of Contents
