Advertisement
3000-LED SLIDER PHASE CONTRAST INSTRUCTIONS
Slider Phase Contrast
Installation & Use Instructions
Objectives
Phase contrast should be used for
observing unstained specimens (i.e.
Green Filter
cultured cells) at high contrast.
Prior to shipment your phase contrast set
was assembled, tested and inspected at
our distribution center in New York. The
phase slider objectives and condenser
were pre-centered and aligned by our
technicians.
IMPORTANT: Before you can use the
phase slider, you must remove the
dust shield cover from the condenser
housing and install the phase annuli
Phase Slider
slider in its place. (See FIG. 1)
IMPORTANT: The condenser has
been intentionally installed in a slightly
rotated orientation. This was done to
prevent accidental contact on the
stage control arm when using the
annuli slider.
In the event the condenser is
removed, it MUST BE REINSTALLED
in the original orientation.
The REFERENCE LINE on the
condenser must be ALIGNED WITH
THE SET SCREW in the condenser
holder.
Advertisement
