Table of Contents
Advertisement
6
ITEM
1
2
3
Center Section Wheel Hubs
4
Center Section/Hitch Pivot
Center Section/Wing Frame Fold (FRONT)
5
Center Section/Wing Frame Fold (REAR)
6
Rubber Roller Scraper
Adjustment
The roller scrapers should be adjusted so that they have
an adequate clearance from the rubber roller grooves but
not excessive
(See Figure
1/4 inch, plugging may occur. 5/32 to 1/4" clearance is
optimum.
•
The rubber rollers are subject to some irregularity in
diameter, especially during initial use or when
returning to duty after have set for a period.
TABLE OF CONTENTS
2
Figure 4-9: Lubrication Schedule
Lubrication Table
DESCRIPTION
Reel Bearings
Wing Wheel Hubs
Main Tilt Cylinder
.) If the clearance exceeds a
6
5
3
4
NO. OF LUBE POINTS
2 per Reel Section
1 each
(2) Check and Re-pack
2 each
2 each
2 each
2 each
•
It is always a good idea to rotate the rubber rollers
after making adjustments to assure an adequate
clearance between the roller and the scrapers.
•
The scrappers will require adjustment periodically as
they wear to maintain the proper clearance.
OPERATION AND MAINTENANCE
5
2
INTERVAL
(Hours Unless Stated)
10
50
250-500
10
10
10
50
1
4-15
Advertisement
Table of Contents
